IBM 39M5657, Руководство пользователя

Страница: 61 / 120

Table 8. Methods of receiving errors and messages (continued)
If the error or message was
presented by.... Do this....
The drive’s SCD and the Status Light
flashes amber
See “Error Codes and Messages.” To determine the meaning of Status Light
activity, see “Status Light” on page 11.
The drive’s SCD and the Status Light
is solid amber
See “Diagnostic and Maintenance Functions” on page 15. To determine the
meaning of Status Light activity, see “Status Light” on page 11.
SCSI log sense data (such as
TapeAlert flags) and SCSI drive sense
data at the server console
See “Error Codes and Messages.”
Drive sense data sent to a library (if
the drive is enclosed in a library)
Refer to your library’s documentation, then see “Error Codes and
Messages.”
The drive’s error log See “Error Codes and Messages” and “Viewing the Drive Error Log” on
page 49.
Error Codes and Messages
The table below gives descriptions of the errors and messages that pertain to the
drive, and tells what to do when you receive them.
Attention: If the drive detects a permanent error and displays an error code other
than
0
, it automatically performs a drive dump. If you force a drive dump, the
existing dump will be overwritten and data will be lost. After you force a drive
dump, do not turn off the power to the drive or you may lose the dump data.
Table 9. Error codes on the Single-character Display . To clear error and cycle power, press the Unload Button for ten
seconds. A drive dump will be created.
Error Code Cause and Action
0
No error occurred and no action is required. This code displays:
v
When power is cycled (turned off, then on) to the tape drive.
v
When diagnostics have finished running and no error occurred.
Note: The Single-character Display is blank during normal operation of the tape drive.
1
Cooling problem. The tape drive detected that the recommended operating temperature was
exceeded. Perform one or more of the following actions:
v
Ensure that the cooling fan is rotating and is quiet. If not, refer to your enclosure
documentation.
v Remove any blockage that prevents air from flowing freely through the tape drive.
v
Ensure that the operating temperature and airflow is within the specified range (see “Physical
Specifications” on page 69).
v
If the operating temperature is within the specified range and the problem persists, replace the
drive.
The error code clears when you power-off the tape drive or place it in maintenance mode.
8
Power problem. The tape drive detected that the externally supplied power is approaching the
specified voltage limits (the tape drive is still operating) or is outside the specified voltage limits
(the tape drive is not operating). Perform the following action:
1. Ensure that the power connector is properly seated.
2. Ensure that the proper dc voltages are being applied within the tolerances allowed (see
“Physical Specifications” on page 69).
3.
If the proper voltages are being applied but the problem persists, replace the unit.
The error code clears when you power-off the tape drive or place it in maintenance mode.
Using Ultrium Media
45