IBM 39M5657, Руководство пользователя

Страница: 72 / 120

__ Step 10. Test the drive (see “Connect and Test Power to the Drive” on page 9)
to determine if it should be replaced.
Tape Pulled from or Broken near Leader Pin
1
Loader motor worm gear
6
Threader mechanism gear
2
Cartridge loader tray guide
bearing
7
Lever
3
Rotator stub
8
Loader mechanism gear
4
Threader motor worm gear
9
Threader worm gear
5
Threader intermediate gear
__ Step 1.
From the left side of the drive, pull out tape from the take up reel.
Note: If there is more than approximately 0.6 m (2 ft.) of tape on the
take up reel, go to “Tape Broken in Mid-tape” on page 57.
__ Step 2. If there is less than approximately 0.6 m (2 ft.) of tape on the take up
reel, cut off the excess tape as close to the leader pin, as possible.
__ Step 3. Locate the threader motor worm gear
4
the rear of the drive. You
can either:
a.
Use your finger to rotate the threader motor worm gear and
slowly rotate the threader mechanism gear
6
clockwise; or
b. Use a #1 flathead screwdriver to turn the threader worm gear
9
clockwise.
This rotates the threader motor worm gear
4
clockwise, drawing the
tape leader block assembly (LBA) into the cartridge.
a82ru009
1
2
3
4
5
6
7
8
9
Figure 21. Drive with cover removed to reveal gear train.
56
IBM 400/800GB LTO3 Tape Drive User’s Guide