IBM 2210, Руководство по установке и первоначальной настройке

Страница: 50 / 72

1
Remove the cover from the IBM 2210 as described in “Removing the Cover”
on page 25.
2
As you face the machine the DRAM SIMM is located in the left slot. To
replace the DRAM SIMM you must remove the existing DRAM SIMM and
install the replacement. The Flash SIMM location is shown in
Figure 32 on page 33
3
Push back the retaining tabs located at each end of the SIMM socket. The
SIMM will fall backwards.
4
Remove the SIMM by gently pulling it away from you.
5
Replace the cover on the IBM 2210 as described in “Reinstalling the Cover”
on page 27.
6
Verify that the IBM 2210 is functioning correctly by using “Verifying
Operation” on page 12.
Installing the Flash and DRAM SIMMs in Models 14T and 24x
Refer to “Handling Static-Sensitive Devices” on page 32 before removing or
installing a flash SIMM.
Figure 33. Installing the Flash SIMM (14T and 24x Models)
1
Remove the cover from the IBM 2210 as described in “Removing the Cover”
on page 25.
2
Tilt the top of the SIMM away from you and slide it into the retainer.
3
Press the SIMM forward until the retaining tabs are holding it securely.
34
2210 Install and Initial Config