Iberital IB7, Инструкция по установке и эксплуатации, Страница: 77 / 443

EN
GLISH
IBERITAL
75 INSTALLATION AND OPERATION MANUAL
2. INSTRUCTIONS FOR THE USER
2.1. DESCRIPTION
1) Coffee feed control buttons (CPU)
2) One-cup espresso feed
3) Two-cup espresso feed
4) Non-stop coffee feed
5) One-cup coffee feed
6) Two-cup coffee feed
7) Steam tap
8) Hot water dispenser
9) Steam dispenser
10) Pump gauge
11) Boiler pressure gauge
12) Three-position switch
13) Red ON/OFF indicator light
14) Green ELEMENTS indicator light
15) Tray
16) Rating plate
17) Removable side panels
18) Hot water control knob
19) Hot water dosage
20) Feed button (automatic versions) 21) Filter holder
21a) Filter holder for one coffee
21b) Filter holder for two coffees
21c) Filter for one coffee
21d) Filter for two coffees
21e) Cleaning filter
22) Permanent thermo-magnetic switch
(Not included. Must be installed by a local authorized
technician)
23) Mains water stopcock
(Not included. Must be installed by a local authorized
technician)
24) Display
25) Drain valve
26) Deposit water inlet (Iberital IB7 Portable)
27) LED lighting
28) USB cable
29) Auto-frother steam outlet (optional)
30) Hot milk button
31) Frother button
2.2. PREPARATION AND START-UP
2.2.1. Stationary coffee machines
a) Open the water stopcock (23).
b) Connect the permanent thermo-magnetic switch (22).
c) Machines with single boilers: Press the switch of the machine (12) and wait until the automatic level
control finishes filling the steam/hot water boiler with water.
d) Machines with two boilers: Press the switch of the machine (12) and wait until the automatic level
control finishes filling the steam/hot water boiler with water. The coffee boiler will fill thanks to the mains
pressure (it is recommended that the non-stop coffee buttons (4) are pressed until water comes out of the
groups).
e) Set switch (12) to position 2 and the heating elements will begin to heat the water in the boiler. (Only
necessary on models with 3-position main switch. On models with 2-position main switches, the machine
will begin to heat when the level sensor is covered with water).
Wait until the working pressure is reached. The green indicator light (14) will go out. The boiler pressure gauge will
indicate the desired working pressure (0.08 - 0.1 MPa). In the case of the Iberital Expression Pro machine, the desired
working pressure is (0.1-0.12 MPa).