iBeLink DM22G Blade, Руководство по устранению неисправностей

Страница: 2 / 20

3. Slightly lift the blade up away from the case.
4. If the Blade is now detected, the issue is caused by conductivity and can be fixed by
following the Fixing Blade Conductivity Issue section further below. If the Blade is
still not detected, it could still be a conductivity issue so follow the Fixing Blade
Conductivity Issue guide and test again.
5. After following the Fixing Blade Conductivity guide, check if Blade is detected
without installing the black and steel bars. Then install the metal bars and check
again to make sure the fix is complete.
II. Not Detecting All Chips
Check to see if the issue is from the panel board, hashing board, or both.
1. Check the panel board: Check the transistors located near the edge of the panel
board to see if any have been knocked off. A few have been circled in the picture
below. If some of the transistors are missing and the number of detected chips is a
multiple of 6, most likely it is only the panel board that is defective. Otherwise,
continue to the next step to check the hashing board.