Ibanez RGD, Инструкция по эксплуатации

Страница: 46 / 217

44
Locking Bridge
FX EDGE III/FX EDGE III-8 BRIDGE
FX Edge III
■
1
1
2
3
4
5
6
1
Main stud
2
Saddle lock bolt
3
String holder block
4
String stopper bolt
5
Rear stud
6
Fine tuning bolt
ADJUSTING THE ACTION
1
To adjust the string height, use a slotted screwdriver to turn the main
studs at the left and right of the bridge unit to adjust the height of the entire
tremolo unit. (It is not possible to adjust the height of individual strings.)
2
Use an Allen wrench (3 mm) to turn the rear studs, adjusting them so
that the bridge is approximately parallel with the surface of the guitar body.
As the action will change when you adjust the rear studs, it is recommended ※
that you check the fi nal action after you
ʼ
ve adjusted the rear studs.
To prevent the screw holes from being damaged, loosen the strings suffi ciently before you adjust the main studs so
that you will not have to use excessive force when turning the studs.
ADJUSTING THE INTONATION
1
Use an Allen wrench (3 mm) to loosen the pressure pad bolts of the locking
nut, and loosen the strings suffi ciently.
2
Use an Allen wrench (2 mm) to loosen the saddle lock bolt, and adjust the
saddle position.
Before checking the intonation, fi rmly tighten the saddle lock bolts and tune ※
the guitar correctly. When you ʼ ve fi nished making adjustments, tighten the
saddle lock bolts and the pressure pad bolts of the locking nut.
NA12G133.indb 44 NA12G133.indb 44 2012-10-24 11:15:59 2012-10-24 11:15:59