ibaMBox
Manual
Issue 1.3
11
4
Safety instructions
4.1
Proper use
The device is an electrical apparatus. It may only be used for the following applications:
Measurement data acquisition and analysis
Applications of the software products (such as ibaPDA) and hardware products of
iba AG.
The device is only to be used as shown in chapter 'Technical Data.'
4.2
Special safety instructions
Be sure to follow the safety instructions of each module in the relevant manuals. The
following notes also apply for ibaMBox.
Observe the operating voltage range.
Only connect the device to a supply voltage corresponding to the specifications on the
built-in power supply.
Never use the device with a damaged power cord.
The device is approved for the CAT II measurement category.
The device must not be connected to CAT III or CAT IV categories.
Important note
Do not open the coverage, the connector panels or the built-in modules. Opening any
of them leads to a loss of warranty!
Repairs must only be carried out by the manufacturer.
Note
Clean the case only on the outside with a dry or slightly damp and statically dis-
charged cloth.
