IAME REEDJET 100cc, Руководство по капитальному ремонту

Страница: 17 / 30

MAN – 086 – ENG - 16
After the check, install O-Ring and cylinder head. Install n°4 head washer, then tighten n°2 Nuts M8
and n°2 Column nuts M8 with SOCKET WRENCH 13mm T-TYPE (18÷22Nm – 160÷190lb-in).
Re-Assembly of The Clutch
Before assembling the clutch, wash with the diluent: the shaft cone, the starter wheel and the clutch
drum.
Assemble the starter wheel on the clutch hub, tighten n°3 M6 TCEI with ALLEN WRENCH 5mm – T
TYPE (10÷12 Nm – 90÷110 lb-in) and the dragging pin. Apply “Loctite” thread locker on screws.
ATTENTION:
IT’S NECESSARY TO ALWAYS INSTALL Ø7mm PIN, EVENTUAL KICKS COULD SHEAR THE SCREWS
Apply “Loctite 641” for coaxial locking. Place the clutch hub and the starter wheel on the shaft.
Insert on the crankshaft and position the ATT.037 STARTER WHEEL LOCKING TOOL.
14