5
Step 3:
Attach the back panel to the second upright by having one person hold the back panel in place
while another person lifts the upright so that the square head bolts can be installed into the milled
slots in the upright nut channel and gently sliding the upright down to the floor. Gently slide the
back panel to the pencil marks on the upright and tighten the hex head keps nuts to hold it in
place. Do not tighten this hardware to more than 10 foot lbs of torque. Attach the top support
bracket by aligning the square head bolts with the milled slots in the upright nut channel and
gently sliding it to the pencil marks and tighten this hardware to a maximum of 10 foot lbs of
torque. Do not over tighten the hardware.
Step 4:
Attach the add-on back panels and top support brackets to the starter uprights by repeating Step
2 above. Be sure to maintain the same back panel and top support bracket height so that the
worksurface heights will be the same.
Step 5:
Attach the next add-on upright to the back panel and top support bracket to by repeating Step 3
above. Be sure to maintain the same back panel and top support bracket height so that the
worksurface heights will be the same.
