21
Step 1:
Fit the power-up cable end connector into the trim panel of the upright by tilting it in and down into
the trim panel cut out and pushing it flat against the distribution block. Then push the connection
end of the connector up into the distribution block. Secure the power up connector to the
distribution block with the screws found in the above hardware kit.
Step 2:
Install the bezel around the power-up cable by sliding it into place and fit it over the cutout in the
trim panel and gently snap it into place.
Step 3:
Install a Duplex Trim bezel and the Duplex Trim Bezel Blank to the bottom left side of the left
upright. Note: If Bezel Blank needs to be removed, insert a flat screwdriver into one of the side
slots and slowly pop it out.
