2. Press the «
+
» and the «
-
» buttons simultaneously
and hold them for not less than 3 seconds.
A large figure showing current ambient temperature will
flash and a sign (fig.4) appears indicating sensor adjustment
mode.
Pressing the «
+
» and the «
-
» buttons set the indicated cur-
rent temperature equal to the temperature shown by your
room air thermometer. At that time the appropriate data shift
is displayed in the top right corner of the screen.
When you are finished with your adjustment you can exit
this mode by simultaneously pressing of the«
+
» and the «
-
»
buttons and holding them for not less than 3 seconds.
The device leaves the data shift mode automatically, approx-
imately 40 seconds, after the last button was pressed.
Control of heating system operating conditions
The
I•WARM
thermostat permanently controls the oper-
ating condition of the heating system. If the heating
of the floor surface to the preset temperature appears
to be impossible ATTENTION sign is displayed.
11
