9
9. Using the AC power adapter that came with your Ethernet switch (not included),
plug the DC barrel connector into the power input jack, then plug the other end
into a nearby AC power outlet.
10. If you are not using an Ethernet switch with PoE support or if you want to power
the transmitter using the included AC power adapter, plug the DC barrel
connector on the other AC power adapter into the DC 5V (4) jack on the
transmitter, then plug the adapter into a nearby AC power outlet. The Power LED
(5) on the transmitter front panel will illuminate. At the same time the Data
Transmission LED (7) on both the transmitter and receiver front panel will start
flashing slowly to indicate that a connection is being established. Once the
connection is completed, the Connection LED (8) on each unit will illuminate.
11. Start playing video content on your video source device. As data is being
transmitted, the Data Transmission LED (2) on each device will start flashing
rapidly, indicating that data is being transmitted and received. Verify that video
is being displayed on each remote television.
12. Use your video source device's remote control at the remote televisions to verify
that you can control the video source device from the remote locations.
Congratulations, your
MN-H-C5-8211
system is now installed and ready for
use!
Unlimited Operation
The extender can be operated in "unlimited" mode, with up to 254 receivers connected
to a series of multiple Ethernet switches. These switches can be cascaded or can be part
of an existing Ethernet network. This mode requires the use of multiple Ethernet
switches (not included) and can be used with the Power over Ethernet (PoE) feature,
allowing you to use any of the receivers or the transmitter without using the included
