8
Ethernet switch with PoE support is required. It is highly recommended to use a Gigabit
(1000Mbps) Ethernet switch. Perform the following steps to connect the
MN-H-
C5-8211
system for one-to-many operation:
1. Place or mount the transmitter, all receivers, and your Ethernet switch (not
included) in their desired locations. Note that you can use an existing Ethernet
network.
2. Using a High Speed HDMI® Cable (not included), plug one end into the HDMI
input on your television, then plug the other end into the HDMI Output (2) on
the receiver. Repeat for each receiver and display pair.
3.
Plug the included IR Receiver into the IR In (3) jack on the receiver, then position
the IR receiver bulb in a position so that it can receive IR signals from your
remote control. Repeat for each receiver.
4. Using a High Speed HDMI Cable (not included), plug one end into the HDMI
Input (2) on the transmitter, then plug the other end into the HDMI output of
your video source device.
5.
Plug the included IR Transmitter into the IR Out (3) jack on the transmitter, then
position the IR emitter bulb in a position where it can transmit IR signals to the
video source device.
6.
Using an Ethernet cable wired to the TIA/EIA-568B standard, plug one end into
the
MN-H-C5-8211
RX (6) jack on the receiver, then plug the other end into one
of the ports on the Ethernet switch (not included). Repeat for each receiver.
7. Using an Ethernet cable wired to the TIA/EIA-568B standard, plug one end into
one of the ports on the Ethernet switch (not included), then plug the other end
into the
MN-H-C5-8211
RX (6) jack on the transmitter.
8.
If you are not using an Ethernet switch with PoE support or if you want to power
the receiver using the included AC power adapter, plug the DC barrel connector
on one of the AC power adapters into the DC 5V (4) jack on the receiver, then
plug the adapter into a nearby AC power outlet. The Power LED (5) on the
receiver front panel will illuminate. Repeat for each receiver as needed or
desired.
