7
7. Plug the DC barrel connector on one of the AC power adapters into the DC 5V
(4) jack on the transmitter, then plug the adapter into a nearby AC power outlet.
The Power LED (5) on the transmitter front panel will illuminate.
8.
Plug the DC barrel connector on the other AC power adapter into the DC 5V (4)
jack on the receiver, then plug the adapter into a nearby AC power outlet. The
Power LED (5) on the receiver front panel will illuminate. At the same time the
Data Transmission LED (7) on both the transmitter and receiver front panel will
start flashing slowly to indicate that a connection is being established. Once the
connection is completed, the Connection LED (8) on each unit will illuminate.
9. Start playing video content on your video source device. As data is being
transmitted, the Data Transmission LED (7) on each device will start flashing
rapidly, indicating that data is being transmitted and received. Verify that video
is being displayed on each remote television.
10. Use your video source device's remote control at the remote television to verify
that you can control the video source device from the remote location.
Congratulations, your
MN-H-C5-8211
system is now installed and ready for
use!
One-to-Many Operation
The extender can be operated in a one-to-many mode, with multiple receivers
connected to an Ethernet switch, which in turn is connected to the transmitter. This
mode requires the use of an Ethernet switch (not included) and can be used with the
Power over Ethernet (PoE) feature, allowing you to use any of the receivers or the
transmitter without using the included AC power adapters. To use the PoE feature, an
