- 13 -
Selecting the Mode of Operation
Choose the preferred mode on the i-mop operating panel:
MODE 1: Brush + Water/Solution
MODE 2: Brush (use the Brush only mode if the
is very wet or to scrub stains)
MODE 3: Brush + Dry Vacuum
MODE 4: Brush + Water/So Dry Vacuum
OFF
ECO (Water Saving Mode)
If you press the ECO water saving mode button once, the i-mop will use 40% less water until the ECO mode
button is pressed again to turn off.
Battery Packs Status Indicator
Next to the mode switch are battery packs status indicators. When the battery indicator is red, It means that you
running out of battery power and have approximately 5 minutes left to operate the i-mop.
Controlling the i-mop
Stand behind the i-mop and hold the handle it with one or two hands. Once the trigger on the i-mop handle is
squeezed, the i-mop will move forward. Simply walk behind it. In case of emergency just release the trigger, and
the i-mop brushes will stop immediately, and the vacuum motor will stop in approximately 3 seconds.
The key to optimally using the i-mop is to understand its ability to swivel!
Operating the i-mop is very intuitive and similar to steering a bicycle. The i-mop is designed to move forward. To
turn, stop walking and use your inside hand* to turn the handle in the direction you want to go. The i-mop can
swivel 360 degrees. You can reverse direction - simply wing around with it and follow in the new direction.
* When turning left, your “inside hand” is your left one. When turning right, your “inside hand” is your right one.
Attention:
Do not use the i-mop at an angle greater than arms length because depressing more than 45 degrees
can cause water to get in the vacuum motor.
