12
Before installing the hard disk drives, turn off the power of the recorder first. When replacing the hard disk drives, the procedures
will be same as those of installation. When installing or replacing the hard disk drives for playback use only (hard disk drives that
are formerly used for recording), perform the link process.
Important:
• Firstly, turn off the power of the recorder.
• To discharge your own static electricity, touch a metal part such as a work desk with your hand before starting work.
• HDD is a precision device. Handle carefully so as not to give strong impacts.
• When handling the HDD, hold it by the side. Make sure not to touch the label surface or the board surface of the HDD.
Note:
• Hard disk drives are locally procured. Contact your dealer for purchasing, installing, and replacing the hard disk drives.
• Since the basic installation method is the same, the illustrations for STEP3 to STEP7 in the following procedures use the
WJ-NU101K as an example.
Install the hard disk drives
1
Installation of the hard disk drive
Step 1
Unplug the Power cord from the recorder's Power cord inlet.
Step 2
Remove the 4 screws on the left and right sides of this prod-
uct, remove the 1 screw on the top cover, remove the 1
screw on the middle upper part of the back, and then
remove the top cover.
Step 3
Clip the top of the hook on the HDD HOLDER TOP with your
finger and thumb. Push inward with your thumb to release
the hook, and open the HDD HOLDER TOP.
HDD HOLDER TOP
Hook
HDD HOLDER BASE
Step 4
Remove the AIR CAP that protects the cable connector.
Step 5
Tilt the HDD at an angle and insert the cable connected to
the board into the HDD.
HDD
Cable
