12
Before installing the hard disk drives, turn off the power of the recorder first. When replacing the hard disk drives, the procedures
will be same as those of installation. When installing or replacing the hard disk drives for playback use only (hard disk drives that
are formerly used for recording), perform the link process.
Important:
• Firstly, turn off the power of the recorder.
• To discharge your own static electricity, touch a metal part such as a work desk with your hand before starting work.
• HDD is a precision device. Handle carefully so as not to give strong impacts.
• When storing the HDD for a long period of time, it is recommended to be in an environment with the temperature below
35 °C, the humidity below 60% and no condensation.
• When handling the HDD, hold it by the side. Make sure not to touch the label surface or the board surface of the HDD.
Note:
• Hard disk drives are locally procured. Contact your dealer for purchasing, installing, and replacing the hard disk drives.
Install the hard disk drive
1
Installation of the hard disk drive
Step 1
Unplug the DC plug of the AC power adapter from the DC
jack of the recorder.
Step 2
Remove the two screws on the left and right sides of the
main unit, remove the three screws on the back, and then
remove the top cover.
Step 3
Clip the top of the hook on the HDD HOLDER TOP with your
finger and thumb. Push inward with your thumb to release
the hook, and open the HDD HOLDER TOP.
HDD HOLDER TOP
Hook
HDD HOLDER BASE
Step 4
Remove the AIR CAP that protects the cable connector.
Step 5
Tilt the HDD at an angle and insert the cable connected to
the board into the HDD.
HDD
Cable
Step 6
Make sure that the cable passes through the HDD HOLDER
BASE slot so that they do not come apart, and place the
HDD with the cable plugged in on the HDD HOLDER BASE.
If the cable is not threaded through the slot, pass it through
before placing the HDD.
Pass the cable through the
HDD HOLDER BASE slot.
HDD
