ISH INLINE CONNECTOR Instruction Manual
Document No.
HDM-0006
17
/
22
Confidential C
7. How to release terminals
(Terminal releasing Jig dimentions see Fig32.)
①
Ensure that the secondary lock part have been removed.
②
Hold the wire and push in the terminal lightly. Place the terminal releasing jig into the releasing apertures of the housing (see Figs. 31).
③
Push the releasing jig fully into the lance, then lever up the lance as shown in Fig.35.
Keep the jig in the place and pull the terminal out by holding the wire.
Take caution not to touch the terminals with the jig.
④
If there is any difficulty in pulling out the terminal, do not pull it forcefully. Check that the jig is in the correct place, that it is pushed fully in, etc.
and repeat the procedures
①
to
③
.
Terminal releasing JIG: Part No. AP0004-05-002
Fig 31. Female housing and Direction of release
Fig32. Dimensions : Terminal releasing Jig
Terminal releasing jig
Place flat surface of the jig outside.
DETAIL A
DETAIL B
Terminal releasing jig aperture
