SUNROOF:
NON SUNROOF:
c. Remove UIB-Door assembly and locate two (2) vertical
marks made by clips. Use clip hole template on
page 17 step 25 to mark hole location center at 13mm
(1/2") from top edge of cavity.
c. Remove UIB-Door assembly and locate two (2) vertical
d. Use a measuring scale to mark clearance hole
marks made by clips. Use clip hole template on
locations at 44mm (1 3/4") from plastic flange on front
page 17 step 25 to mark hole location center at 13mm
of console and 13mm (1/2") down from edge of the OHC
(1/2") from top edge of cavity.
flange. Repeat for second hole.
e. Drill pilot hole with 1/16" drill bit with hex head
attached to driver extension. Repeat for second
clearance hole.
INSTALLATION PROCEDURE
Please skip to page 17 step 25 and cut out clip
hole template before proceeding to step 9-c.
c
c
d
e
Please skip to page 17 step 25 and cut out clip
hole template before proceeding to step 9-c.
When marking vertical lines with UIB, the clear lens
may pop off. Retain lens in housing when
measuring with paper template.
When marking vertical lines with UIB, the clear lens
may pop off. Retain lens in housing when measuring
with paper template.
c
c
Page 7 of 17
