SUNROOF:
NON SUNROOF:
b. The molding containing the dome lights MUST be
b. The molding containing the dome lights MUST be
separated from the O/H console by carefully removing
separated from the O/H console by carefully removing
the 4 screws using a #1 Phillips screwdriver. Disengage
the 4 screws using a #1 Phillips screwdriver. Disengage
corner clips and remove. Lay overhead console face
corner clips and remove. Lay overhead console face
down on clean surface. Drill out 25mm (1") harness
down on clean surface. Drill out 25mm (1") harness
hole with 1" Unibit.
hole with 1" Unibit.
ALL STYLES:
9.
Drill Clip Holes
a. Insert UIB-Door assembly into overhead console, making sure that both pivot pins are properly seated in holes
in the overhead console.
b. Use plastic trim removal tool to close sunglass bin door until door is pushed into the closed position. Rock the
bin door up and down to create vertical marks with both clips. Continue to rock the door up and down 5 more times
without opening the door to establish defined vertical contact lines.
INSTALLATION PROCEDURE
b
a
a
b
b
b
Do not lose the screws or scratch the
surfaces / buttons of the molding.
Disengage corner
clips carefully.
Do not lose the screws or scratch the
surfaces / buttons of the molding.
Disengage corner
clips carefully.
b
Page 6 of 17
