IM2021
12
1. Handle
2. Air outlet
3. LED displa
4. State indicator light
5. Remote sensor
6. Operating-elements
7. Air inlet
8. Remote control
7. OPERATION OF THE DEVICE
Control panel
ON/OFF: turn on or turn off the machine.
MODE: select function for FAN/LOW/HIGH mode
UP/DOWN: set desired temperature. or press both and hold for 3s to child lock version,
press and hold for 3s to unlock.
TIMER: set timer, 12hours timer, step 1hour.
Operation
Press ON/OFF switch to turn on the machine
Summer service (ventilation only): Press MODE switch until the state indicator light on FAN.
Heating at reduced power: Press MODE switch until the state indicator light on LOW(750W).
Heating at full power: Press MODE switch until the state indicator light on HIGH(1500W).
Select a desired temperature: Press UP/DOWN switch to set a satisfied temperature. when
you select the desired temperature, it will show on LED display. After operation finished, the
LED display with flash 3s and then show room temperature. the machine will keep heating
until the room temperature 1
℃
higher than desired temperature. when the room temperature
drop 2
℃
lower than desired temperature the machine will start heating again.
Set timer: Press TIMER switch to set timer, the state indicator light on TIMER, and LED
display show 01. Press TIMER switch again to increase the timer; it will cycle from 1H-12H,
per step 1hour.
Switching off: Press ON/OFF switch to switch off the machine.
Remote control
The digital version with a full function remote control with same operation function on the
control panel. Pull out the insulation film when you first use.
The remote control use CR2025 cell button.
OVERHEATING SAFETY DEVICE
A thermal overload protector is built in to prevent overheating. When an overheat temperature
is reached, the heater will be automatically shut off. It can only resume operation when the
user resets the unit.
If the heater does not switch on, the safety device has been activated. Remove the mains
plug from the wall socket. Let the heater cool down for 30 minutes. Check if the heater had
been placed correctly. Check if anything is obstructing the air flow. If necessary, clean the
grilles with a vacuum cleaner. Replace the plug into the wall socket and switch the heater on
again.
NOTE
During the first use, there may be a smell and smoke. Do not worry, this means that a drop of oil
has fallen on the heating element during production. The drop will quickly evaporate - the
appearance of smell and smoke will no longer occur.
