a station this will confirm the set is
operational in this mode.
11)
Confirm CD Mechanism operational.
a) Please insert a CD into CD aperture.
Confirm that CD mechanism is
operational.
b) To remove disc – press the white eject
button.
12) Confirm all four speakers are operational.
Fader and Balance control check.
a) Press volume control repetitively until screen
shows wording, Fader.
b) Turn volume control to left to
check rear speakers
operational.
c) Press volume control repetitively until screen shows wording,
Balance
.
d) Turn volume control to left to check
rear left speakers
operational.
e) Turn volume control to right to check
rear right speakers
operational.
f)
Press volume control repetitively until screen
shows wording, Fader.
g) Turn volume control to left to
check front speakers
operational.
h) Press volume control repetitively until screen shows wording,
Balance
.
i)
Turn volume control to left to check
front left speakers
operational.
j)
Turn volume control to right to check
front right speakers
operational.
Note: Faulty Product.
If any of the above operational points fail to operate,
a. Tuner
operation.
b. CD
Mechanism.
c. Fader
control.
d. Balance control.
Do not complete the installation of the radio.
I.
Remove the radio from the vehicle.
II. Repack the radio into it’s original packaging complete with harness
and owner’s manual and anti-theft security code plastic card.
III. Return the radio to the stores department for packing and despatch
to the HANZ.
IV. Please refer to operational procedures for the return of faulty
product back to the HANZ.
V. Install a new radio following above procedures.
13) Complete installation of radio into dash
14)
Press the radio firmly on the front at
each end (See photo).
When you hear the sound of the click-
lock, this indicates the radio is locked
into the install sleeve.
(If OK go to
step 15)
•
If you cannot hear the click-lock
sound, this suggests the radio is
not locked into position.
17
•
Remove the radio.