7-48
1
2
3
4
6
3
7
1 Adjust cylinder (2EA)
2 Fork (2EA)
3 Tilt cylinder (Left/Right, 2EA)
4 Lift chain (2EA)
5 Chain sheave pin (2EA)
6 Mast support (Left/Right, 2EA)
7 Steering axle (6EA)
8 Hyd pump drive spline (1EA)
8
5
Lubrication points
Lubrication points
Fork adjust cylinder : 2EA
Forks : 2EA
Tilt cylinder : Left/Right, 2EA
Lift chain : 2EA
Chain sheave pin : 2EA
Mast support : Left/Right, 2EA
Steering axle : 6EA
Hydraulic pump drive spline : 1EA
(3)
(3)
160D9LOP17
LUBRICATION
LUBRICATION
Lubricate the grease to grease nipple in
accordance with lubrication intervals.
Shorten lubricating interval when working
Shorten lubricating interval when working
in the water or dusty place.
in the water or dusty place.
After lubricating, clean off spilled grease.
Put the parking brake switch in the LOCK
Put the parking brake switch in the LOCK
position and fix front and rear tires with
position and fix front and rear tires with
blocks.
blocks.
Set the mast and forks in a stable position.
Set the mast and forks in a stable position.
(1)
※
(2)
37)
37)
①
②
③
④
⑤
⑥
⑦
⑧
Fork
Fork
retainer pin
Carriage
Bolt
Fork retainer
Cylinder
retainer pin
160D9LRE51
FORKS REPLACEMENT
FORKS REPLACEMENT
Lower the fork carriage until the forks are
approximately 25 mm (1 in) from the floor.
Loosen the bolt and take out the fork
retainer pin and release the fork retainer
with the fork.
Remove the cylinders at a time out of
carriage assembly.
Remove only one fork at a time.
On larger forks it may be necessary to
On larger forks it may be necessary to
use a block of wood.
use a block of wood.
Reverse the above procedure to install the
forks.
①
②
③
※
④
38)
38)