Hyundai power products HYEA5200X, Инструкция по эксплуатации

Страница: 20 / 40

A
20
Starting Procedure
STEP 1
If the engine is cold, move the choke lever
(A) to the START position. The choke lever
opens and closes the choke in the
carburettor.
If the engine is warm, leave the choke lever to
the RUN position.
CAUTION -
For OUTDOOR use ONLY.
Petrol machines produce carbon monoxide –
a poisonous, colourless and odourless gas that
can cause serious injury or death. Petrol is
highly flammable, always handle with extreme
care and in a well ventilated area.
NOTE - This machine is shipped without
fuel and oil mixture and MUST be filled before
use. Failure to do so may cause damage to the
engine that will not be covered by warranty.
CAUTION! ALL FUELS ARE FLAMMABLE
Always fuel and de-fuel in a well ventilated area
away from sources of ignition. Move the ma-
chine at least 3m away from the refuelling point
before starting.
!
!
• Always ensure that the machine is in a safe
working condition. Inspect the machine, check
safety devices, the condition of the fuel lines
and check all nuts, bolts and screws are
secure. Make sure that the earth auger can
move freely.
• Check the fuel / 2-stroke oil mixture. Go to
page 19 for more information.
• Before starting, make sure the machine is
clear of all materials and non-essential people.
• Make sure you know how to stop the engine
before starting.
WARNING - If you are not familiar with
this type of machine, you should seek advice
and guidance from your dealer.
!
CAUTION
!
• Always start slowly with half throttle and
keep a firm grip on both handles of the auger
at all times. Keep a wide stance.
• After engine warms up, accelerate the
engine. To accelerate the engine to working
speed, squeeze the throttle lever toward the
main handle.
• Do not force the auger drill bit into the
ground - instead allow the machine to do the
work. If the machine jams you MUST release
the throttle and move the auger drill bit before
re-commencing work.
• To remove blockages DO NOT under any
circumstance use your hands. STOP and
disable the machine and clear the auger drill
bit of materials which have become stuck to
the auger bit.
WARNING -
You MUST STOP using the
machine if any of the following occur:
• The engine speed changes with no control
• In case of misfire
• In case of high vibration
• When flames or smoke appear
• In rain or stormy weather
!
Before Each Use
Starting Procedure