12
DISASSEMBLING
-
Insert the 4mm Allen wrench into the middle hole of the belt protection.
-
Use the cross sleeve M10*20 outer hexagon screws to loosen the screw.
-
Remove the small plate, the big plate, the cutting plate and the second big plate.
4. FILLING FUEL TANK
FUEL AND OIL
Caution:
This tool uses petroleum products (gasoline and oil).
Be especially careful when handling gasoline.
Do not smoke. Do not allow gasoline to come near flames,
sparks or tire (explosion hazard)
Fuel mixture
This tool is powered by a high-performance air-cooled
two-stroke engine. It runs on a mixture of gasoline and
two-stroke engine oil.
The engine is designed for unleaded regular gasoline with a min
octane value of 89 (R+M)/2. In case no such fuel is available,
you can use fuel with a higher-octane value. This will not affect the engine.
In order to obtain an optimum engine output and to protect your health and the environment use
unleaded fuel only.
To lubricate the engine, use a synthetic oil for two-stroke air-cooled engines, which must be added to the fuel.
The correct mixture ratio 40:1 (40-part gasoline to 1-part oil)
Allen wrench
Cross sleeve
