14
5. OPERATION
STARTING THE ENGINE
CAUTION:
Start the Concrete Cutter only after complete assembly and
inspection.
a) Move at least 3m (10 feet) away from the place where you fueled the Concrete Cutter.
b) Make sure you have a good footing and place the Concrete Cutter on the ground in such a way that the
cutting disc is not touching anything.
WATER SUPPLY
A water supply line (from a pressurized water tank or other source) is connected by the water set on the
protective cover. The water flow rate can be adjusted with the adjusting screw. Press the 1/2
” hose into the
holder.
For a slower flow, turn the adjusting screw clockwise.
For a faster flow, turn it counter-clockwise.
COLD STARTING
-
Switch on the machine by pushing the ON/OFF (I/0) on the position I.
-
Pull the choke lever. It will close and the throttle will be moved to the starting position.
-
Pull starter cable smoothly until you hear the first Ignition
(max. 3-5 pulls).
CAUTION
Do not pull the starter cable more than about 50
cm/20' out.
-
Push the choke lever.
Pull the starter cable smoothly.
-
As soon as the engine is running, grasp the rear handle and
press the lock trigger and the trigger.
WARM STARTING
As described above for cold starting, it doesn't need to pull the choke lever. If the engine doesn't start after 2
or 3 pulls, repeat the entire starting procedure as described for cold starting.
Note
If the engine was switched off only for a short time, the saw can be started without using choke lever.
STOPPING
Switch off the machine by pushing the ON/OFF button (I/O) of the position O.
Wait until the total stop of the disc before doing the maintenance and storing the machine.
