6
Features
Available features of this radio are listed below. Please
refer to the corresponding Feature Book for details.
Feature Type
Detailed Feature
Radio Features
●
Radio setting: Power Level,
LED Indicator and Alert Tone
●
C o n v e n i e n t f u n c t i o n a l i t y:
Shortcuts, One Touch Call and
VOX
●
Security: Lone Worker
●
Rent
●
Audio Optimization
●
Positioning
Conventional
Common
Features
●
Scan
●
Talk Around
Digital Features
●
Access management
●
Basic voice services: Private
Call and Group Call (See Calls
on Digital Channel
in this
manual)
●
Auxiliary voice services: All Call
(See Calls on Digital Channel
in this manual) and Phone
●
Security
●
Supplementary services
●
Patented features
●
Mobility management
Analog
Features
●
Access management
●
Voice services (See Calls on
Analog Channel (No Signaling)
in this manual)
●
Security
●
Signaling
Features
Developed with
Third Party
●
API
●
Accessory Connector
Troubleshooting
Phenomena
Analysis
Solution
The radio fails to power on.
The power cord may be disconnected.
Properly connect the power cord.
During receiving, the voice is
weak, discontinuous or totally
inactive.
The volume level may be low.
Increase the volume via the remote
speaker microphone.
The antenna may be loosened or
improperly installed.
Power off the radio and reattach the
antenna.
The speaker may be blocked or damaged.
Clean the surface of the speaker. If the
problem cannot be solved, contact your
dealer or authorized service center for
inspection and repair.
You cannot communicate
with other members in analog
mode.
The frequency or signaling may not match
that of other members.
Set your TX/RX
frequency and signaling
to the same as that of other members.
You may be too far away from the group
members.
Move towards other members.
In digital mode, there
’
s RX
indication on the radio, but
unable to communicate with
other members.
The digital carrier may be received but may
not be demodulated due to inconsistent ID
with that of other members.
Sets the same ID of other members.
Irrelevant communication
or noise is heard on the
channel.
You may be interrupted by radios using the
same frequency.
Adjust the squelch level.
The radio may be set with no signaling.
Set your radio with signaling to avoid
interference at the same frequency, and
make sure that all members share the
same signaling.
The noise is too loud.
You may be too far away from other
members.
Move towards other members, and then
try again.
You may locate in an unfavorable position.
For example, your communication may be
blocked by high buildings or frustrated in
the underground areas.
Move to an open and flat area, and restart
the radio to try again.
You may suffer from external disturbance
(such as electromagnetic interference).
Stay away from equipment that may cause
interference.
No indication on the LCD
of the remote speaker
microphone.
The LCD may fail to function temporarily.
Restart the radio or reassemble the
remote speaker microphone.
GPS positioning failure.
The GPS antenna may be connected
improperly.
Properly connect the GPS antenna.
GPS signals may not be received due to
unfavorable position.
Move to an open and flat area to try again.
If the above solutions cannot fix your problems, or you may have some other queries, please contact us or your
local dealer for more technical support.
