![background image](http://html1.mh-extra.com/html/hyster/h170ft/h170ft_service-and-repair-manual_2194315013.webp)
Spindles, Bearings, and Tie Rods Repair
SPINDLES AND BEARINGS
Remove
WARNING
PUTTING THE LIFT TRUCK ON BLOCKS
The lift truck must be put on blocks for some
types of maintenance and repair. The removal of
the mast, drive axle, battery, or counterweight as-
semblies will cause large changes in the center of
gravity. When the lift truck is put on blocks, put
additional blocks in the following positions:
•
If the mast and drive axle are removed, put
blocks under the counterweight so the lift
truck cannot fall backward.
•
If the counterweight is removed, put blocks
under the mast so that the lift truck cannot
fall forward.
Put the lift truck on blocks on a solid, even, and
level surface. Verify the blocks or stands have
enough capacity to hold the lift truck. Use addi-
tional blocks next to the tires as necessary to pre-
vent movement of the lift truck. Verify the lifting
devices used during repairs can lift the weight of
the parts and assemblies.
See the Operating Manual or Periodic Mainte-
nance manual listed in the General of this manual,
for the procedures to put the lift truck on blocks.
1.
Put the lift truck on blocks.
2.
Remove the wheel and bearings. See Steering
Axle Assembly Repair for procedures.
3.
Remove two snap rings and washers from the
pin holding the tie rod to steering cylinder rod
and remove pin. See Figure 6.
CAUTION
DO NOT hit the threads of the tie rod.
4.
Remove snap rings, washers and pin. Remove
tie rod end from spindle arm. See Figure 6.
5.
If necessary, repeat above steps for other spin-
dle and tie rod.
Disassemble
1.
Remove plug from the top of spindle. Remove
the capscrews from the bearing cap. Remove
the bearing cap and shims. If necessary, re-
move the bearing cup from the bearing cap. See
Figure 7.
2.
Tilt the spindle and lift the spindle from the
axle. If necessary, remove the bearing and seals
from the spindle. If necessary, remove the wear
sleeve and bearing cup from the axle frame.
3.
If necessary, repeat above steps for other spin-
dle and tie rod.
1600 SRM 1952
Spindles, Bearings, and Tie Rods Repair
7
Содержание H170FT
Страница 1: ...Hyster C299 H170FT F175FT36 F190FT Internal Combustion Engine Trucks Service Repair Manual ...
Страница 5: ... THE QUALITY KEEPERS HYSTER APPROVED PARTS ...
Страница 20: ...NOTES 14 ...
Страница 21: ......