1. HARNESS CONNECTOR
2. STEERING HANDLE
3. CAPSCREW
Figure 5. Steering Handle
8.
Remove three capscrews that hold steering
handle assembly to lift truck. See Figure 5.
9.
Remove steering handle assembly from lift
truck and place assembly on a clean work
surface.
Install
1.
Connect harness for steering handle assembly
to connector on main truck harness. See
Figure 5.
2.
Using three capscrews, install steering handle
assembly onto lift truck. See Figure 5.
3.
Position console cover onto lift truck. See
Figure 4.
4.
Connect wiring to console cover as noted and
tagged during removal.
5.
Install seven capscrews that secure console
cover to lift truck. See Figure 4.
6.
Close drive unit compartment door.
7.
Connect battery to lift truck.
8.
Turn key switch to the ON position and test for
proper operation.
Console Tray
Remove
1.
Remove four capscrews and four washers from
console tray. See Figure 6.
2.
Remove console tray from heat shield and
frame assembly. See Figure 6.
3.
Remove heat shield from frame assembly. See
Figure 6.
Install
NOTE:
Align tabs on heat shield with slots in
frame.
1.
Install heat shield onto frame. See Figure 6.
2.
Install console tray into heat shield and frame
assembly. See Figure 6.
NOTE:
Align holes in console tray with clips on
frame to aid in installation.
3.
Install four washers and four capscrews into
console tray and frame. See Figure 6.
1. CAPSCREW
2. WASHER
3. CONSOLE TRAY
4. HEAT SHIELD
5. FRAME ASSEMBLY
Figure 6. Console Tray
General
8000 SRM 1705
4
