816 LA Actuator
INSTALLATION REFERENCE MANUAL
11
1. Weld the gate bracket to the gate supporting structure (IMAGE 5-1).
2.
If welding is not possible, drill two holes to match bracket and affix with two 3/8”x2.5” screws
and 3/8” nuts included in the kit (IMAGE 5-2).
IMAGE 5-1:
GATE BRACKET WELDED TO GATE
IMAGE 5-2:
GATE BRACKET AND HARDWARE (BLACK BRACKET SHOWN)
5
AFFIX GATE BRACKET TO GATE
GATE BRACKET
3/8”x2.5” HEX BOLT (x2)
WELD
3/8” NUT (x2)
1/2”
GATE BRACKET
CENTERLINE
ACTUATOR
ARM
IMPORTANT!
Ensure bracket centerline is 1/2” above the top of the pivot arm.
GATE BRACKET
IMPORTANT!
Use a bubble level to assure after mounting that actuator is level and plumb.
CAUTION!
NEVER WELD PARTS TO THE GATE OR POSTS WHEN THE CONTROL BOARD IS
POWERED TO AVOID IRREPAIRABLE DAMAGE TO THE CIRCUIT BOARD!
1/2” FROM TOP
SURFACE OF PIVOT
ARM TO CENTERLINE.
SEE INSTRUCTION 1A
& 1B.
www.ApolloGateOpeners.com | (800) 878-7829 | [email protected]
