HyQuest Solutions BAROSSA DDT700, Инструкция по эксплуатации

Страница: 5 / 35

HyQuest Solutions Pty Ltd
DDT700
© Copyright
Page 5 of 15 ISSUE 6: March 20
Dismantling Procedure:
1. Traverse traveller block to operating side position.
2. Tie traveller block in position near winch.
3. Attach soft clamp to traversing cables and main cable on river side of traveller block.
4. Disengage traversing drum, then lower sounding weight to the ground (thus reducing tension
in the cables).
5. Remove traversing cable from drum and connect to anchorage chain with padlock. Refer to
appendix
6. Loosen soft clamp, remove traversing cable end from traveller block, pull cable in and attach
to padlock.
7. Tighten soft clamp.
8. Remove traveller block from main cable.
9. Disconnect current meter, weight and current meter counter.
10. Wind on Amergraph cable and secure Cl Connector to tension spring.
11. Remove winch from mountings.
Winch Mode:
Barossa Winch shown in "winch mode", that is the traverse drum is out of mesh with the sounding
drum and is prevented from rotating by the drum stop. In this mode, the sounding weight can be
raised and lowered whilst the traversing block remains stationary
It will be observed that if the winch handle is released, the weight will be held in position - this is due
to the automatic (Weston) brake. To lower, it is necessary to wind the weight down. This again is due
to the influence of the Weston brake. For the brake to operate in this manner, the pawl must engage
with the ratchet wheel on the operating shaft. With the pawl engaged, a loud click will be heard as the
handle is rotated in a clockwise direction.