HyQuest Solutions BAROSSA DDT700, Инструкция по эксплуатации

Страница: 12 / 35

HyQuest Solutions Pty Ltd
DDT700
© Copyright
Page 12 of 15 ISSUE 6: March 20
FITTING ANGLE PLUG TO AMERGRAPH CABLE
1. Slide nut and flanged bush onto Amergraph cable.
2. Wrap insulating tape around cable 25mm (1") from end, or fit heat shrink, 20mm (3/4") long.
3. Unwind outer layer of cable and cut off at tape.
4. Unwind inner cable layer back to tape, one strand at a time and cut off 3mm (1/8") in
front of the insulation tape.
5. Slide flanged bush forward and bend the short inner layer strands onto the bush.
6. Strip conductor insulation back to 8mm (5/16") in front of the flanged bush.
7. Coat copper conductor wire with resin-cored solder. BE CAREFUL not to heat wire
insulation. Cut wire back to 4mm (5/32") long.