© Copyright 2021 HYPERVSN. All rights reserved
17
Turning the Device(s) off
1.
Press the “Off” button o
n the remote control, pointing the remote control towards
the IR-sensor. The Device/the Wall Devices will stop displaying the current media
/starting media (Picture 11). If any audio facilities are connected to the MasterBox,
the audio content output will also be stopped.
2.
Disconnect the Device(s) and audio facilities (if any) from the power mains / switch
the line filter(s) off.
Connecting a router
To activate the MasterBox, the Device / Wall Devices (see section 7) and to control them
via the Wall App, make sure that the MasterBox, the
Device(s) and your computer are
connected to a router (as shown in the connection scheme in
).
To connect the MasterBox to your router, use an Ethernet cable (use the Ethernet socket
of the MasterBox,
Attention.
The location of the router must comply with the technical requirements in
section 2
The router
’s
location can make a major difference to the Wall
’s
operation.
How to pair the remote control with the MasterBox
Note.
Perform this procedure only if your remote control
doesn’t operate properly.
1.
Disconnect the sync cable from the MasterBox. Ensure the IR-sensor cable is
connected to the IR 3.5 jack socket (Picture 10).
2.
With a thin tool (a
straightened paper clip or similar object
), press and hold the
“Reset” button on the bottom side of the Masterbox up to 3 seconds.
Picture 12
. The “Reset” button
3.
Immediately after the “Reset” button have been released, the “Devices” indicator
of the MasterBox (Picture 10) will start blinking frequently.
4.
Point the remote control to the IR sensor and press
the “On”
button on the remote
control.
5.
If pairing has been completed successfully, the indicator will stop blinking
immediately.
6.
After finishing the procedure, connect the sync cable again.
Attention.
Do not hold the “Reset” button pressed
for longer than 5 seconds. It will reset
the MasterBox to its factory settings.
“Reset” button
The “Reset” button is designed to reset the MasterBox’ settings to
factory ones.
Reset button
