Hypertherm Abrasive pot, Инструкция по эксплуатации

Страница: 35 / 36

Abrasive pot
Instruction
Manual 809080 35
6 – Installation
Inst
allation
Connect the compressed air to the pot
Required parts, tools, and materials
1/4-inch air hose with a 1/4-inch industrial hose coupling
Compressed air source
1. Connect the air hose to the compressed air source.
2. Connect the other end of the air hose to the 1/4-inch quick connect on the air regulator.
Do the first startup
1. Make sure that the pot is installed correctly and that all of the hose connections are tight.
2. Set up the abrasive regulator according to the manufacturer’s instructions. Make sure that the abrasive
regulator is closed.
3. Plug the cord from the low-level sensor box into a 115 V outlet.
4. Remove the cover.
5. Pour the abrasive through the filling screen into the pot until the low-level sensor light turns off.
6. Pressurize the pot.
a. Open the ball valve.
b. Remove the cover. Pull up on the plug on top of the filling screen.
7. Replace the cover.
8. Adjust the pot pressure to 40 psi. For longer delivery lengths, increase the pot pressure
.
Do not exceed 80 psi.