Installation Instructions
1. Inspection
Inspect the UPS upon receipt. The packaging is recyclable. Save it for
reuse or dispose of it properly. Ensure the UPS is physically undamaged
due to transit.
2. Placement
Install the UPS in a protected area with adequate airflow, and away from
direct sunlight and excessive dust. Do not operate the UPS where the
temperature and humidity is outside the specified limits in the
Specifications Table.
3.
Connect to Mains Power
Connect the AC input power cord to a socket outlet to power up the UPS.
The battery in the UPS will lose some charge during shipping and storage.
It will recharge completely after approximately 8 hours of normal operation.
Do not expect full battery run time during this initial recharge period.
4. Connect
the
loads
Plug the loads into the output sockets on the rear of the UPS. Ensure the
UPS is sized correctly so that the UPS is not run at full load constantly.
Caution: NDO NOT connect a laser printer or plotter to the UPS with other
computer equipment. A laser printer or plotter periodically draws
significantly more power than when idle, and may overload the UPS.
9
