Hyperflight X-res, Инструкция по эксплуатации

Страница: 14 / 37

X-RES
14 Of 37
2.4 Construction Stage - Wing
The material for the sheeting of the wing should be cut in each phase of construction.
Some small pieces, however, are not shown here. Therefore, do not throw away the cut off
pieces.
2.4.2 Building Phase – Center Wing Section
2.4.2.1 Material Center Wing
1 sheet 5 mm Balsa root ribs A-1
1 sheet 1.5mm plywood A-reinforcing ribs A-2
1 sheet 3 mm plywood ribs and ribs for the wing joints
1 sheet 2.5mm balsa ribs
1 sheet 3.0mm balsa leading edge sanding templates
2 sheets 1.5mm balsa planking inside wing
1 sheet 2 mm balsa trailing edge inner wing
1 sheet 3mm balsa for spoilers
1 strip 3x3 mm balsa auxiliary web airbrakes
1 strip 4x10 mm balsa leading edge
2 6x2 mm spruce spar caps for center wing
2 carbon fiber rods 6 mm Ø, wing joiners
2 ALU tubes 58x7 mm joiner tubes
1 angle template 5 ° (plywood) alignment of the ribs A-9, B-1 for dihedral
2.4.2.2 Construction of the Center Wing
The printed plan must be glued together from the individual pages.
Tape he plans together using the alignment marks on each page.
Use a long ruler to check alignment of plans. Spar lines should be straight. See below.
First the 6x2 mm spruce spars are cut to length, slightly oversized.
Now a 1.5mm balsa sheet (bottom sheeting) is glued to the edge of the spruce spar.
Care must be taken to ensure that the parts are accurately aligned. The balsa can
now be cut off at the front, but it should extend about 5 mm in front of the ribs.
The balsa that is cut off should be saved for possible use in the future.