HYOSUNG MONiMAX8100QTN, Руководство оператора

Страница: 39 / 112

Operator Manual Chapter4. Receipt Printer (SPR60)
© Hyosung TNS Inc. All Rights Reserved. 4-1
Chapter4. Receipt Printer (SPR60)
Introduction
► Information in this section is subject to change without notice. Hyosung TNS reserves the right to
improve products as new technology, components, software, and hardware become available. If
users need further data about these products, please feel free to contact Hyosung TNS or your
local dealer.
No part of this document may be reproduced or transmitted in any form or by any means for any
purpose without the express written permission of Hyosung TNS.
► Warning and caution:
Caution: Items shall be strictly followed to avoid injury or damage to body and equipment.
Note: Items with important information and prompts for operating the printer.
Heating: Thermal elements. No touching.
Warning: Do not touch equipment to avoid damaging it for static electricity.
► Safety instructions
Before installing and using the printer, please read the following items carefully:
1. Install the printer on a flat and stable surface;
2. Reserve adequate space around the printer so that convenient operation and maintenance
can be performed;
3. Keep the printer far away from water source, and do not expose the printer to direct sunlight,
strong light and heat;
4. Do not use or store the printer in a place exposed to high temperature, high humidity or
serious pollution;
5. Do not place the printer in a place exposed to vibration or impact;
6. No condensation is allowed to the printer. In case of such condensation, do not turn on the
power until it has completely gone away;
7. Connect the printer power to an appropriate grounding outlet. Avoid sharing one electrical
outlet with large power motors or other devices that may cause the fluctuation of voltage;
8. Disconnect the power when the printer is deemed to idle for a long time;
9.
Don’t spill water or other electric materials into the printer (e.g. metal). In case this happens,
turn off the power immediately;
10. Do not allow the printer to start printing when there is no recording paper installed; otherwise
the print head and platen roller will be damaged;
11. To ensure quality print and normal lifetime, use recommended paper or its equivalent;
12. Shut down the printer when connecting or disconnecting interfaces to avoid damages to
control board;
13. Set the print darkness to a lower grade as long as the print quality is acceptable. This will
help to keep the print head durable;
14. Do not disassemble the printer without permission of a technician, even for repairing
purpose;
15. Keep this manual safe and at hand for reference purpose.