Hydrotechnik MultiControl 4070, Руководство по эксплуатации, Страница: 29 / 39

Firmware Version 1.2 MultiControl 4070
29
Operation
ENG
Configure and operate the instrument
HYDROTECHNIK recommends that a USB connection is used to commission
the instrument initially. To do this, use the USB (Type C) data transmission ca-
ble included in the scope of delivery.
The instrument is configured and operated with the HYDROlink6 Advanced
software. The software is included in the scope of delivery. For more informa-
tion, consult the documentation in the download area of our website at
www.hydrotechnik.com .
 Configuring the measuring instrument
1 Install the HYDROlink6 Advanced software on a PC/laptop.
2 Switch on the measuring instrument and PC/laptop.
3 Connect the measuring instrument and PC/laptop with a USB-C cable.
 Connections on page 11
4 Wait until the measuring instrument is detected.
5 Configure MultiControl 4070 from the PC/laptop.
 Configuration tasks in HYDROlink6 on page 29

Configuration tasks in HYDROlink6
Before you can begin measuring with MultiControl 4070 , you must configure
the instrument with the HYDROlink6 software.
Depending on the measuring task, it may be necessary to carry out other con-
figuration tasks, for example:
• Set sensor parameters (not necessary for ISDS sensors)
• Define recording parameters
• Define display parameters
• Define CAN channels (if used)
The HYDROlink6 software operating instructions can be found in the down-
load area of our website at
www.hydrotechnik.com .