HydroHoist HarborHoist 12000, Руководство по эксплуатации

Страница: 5 / 18

Rev A 2003215
Four Valve Control General Operation
Familiarize yourself with the Control Box. We have created a simple to use 4 BUTTON user interface con-
sisting of UP, STOP, DOWN, and LEVEL buttons. These are the basic functions for operating the HarborHoist
lift. The state-of-the art valve controls and circuitry will insure that your lift comes up level each and every
time you lift your boat from the water.
Lowering the lift:

Make sure the Power LED is illuminated and flashing

Press the DOWN button, this will open the valves

Allow the lift to submerge (walkways will remain above water)

Untie lift safety lines from boat

Board the boat only after it clears the lift
Raising the lift:

Make sure the Power LED is illuminated and flashing

Float boat into established balanced lifting position on the lift

Tie off safety lines to the boat

Everyone must exit the boat before lifting

Press UP button

Once the lift is fully raised, air bubbles will be visible exiting from ALL main tanks

Press STOP on control
Re–level the lift:
If for some reason the lift should become out of level while in the up position perform the following:

Press the LEVEL button. This will open up the valves necessary and lower the high points of the lift to
make it level. The control will shut off once the lift is level. You can then proceed with either lifting or
lowering the lift as desired

Note: you may want to check for leaks in the air system, this could be the cause of the lift becoming un-
level over time.