45
Rev. 07142020
STEP 18: COMMISSIONING THE LIFT
Perform the following steps after the lift has been installed, WITHOUT a vessel on the hoist.
1.
With the lift completely lowered calibrate the level sensor. Please reference the HarborHoist Own-
er
-
Operating Manual for the procedure and functionality.
2.
Raise the hoist until all main tanks are bubbling air. Stop the hoist. If the HarborHoist lifted level
then lower and position vessel on the lift. The next step may take some trial and error to the get
the vessel to balance properly on the lift. The best balance is with the center mass of the boat to
be within
6”
of the center of buoyance of the lift. See the Appendix for location of each models cen-
ter of buoyance.
3.
If the hoist does not raise level, lower the lift and reposition the vessel on the lift and re
-
raise. Do
this until the lift raises level or just slightly rear angled down so rain water can drain to the rear of
the vessel.
4.
With the vessel fully raised recalibrate the level sensor. See the Owner
-
Operation Manual for the
procedure.
5.
Lower and raise the lift once more to verify level operation.
6.
While the hoist is completely raised, verify with soapy water that there are no leaks at any connec-
tion in the air system.
7.
While in operation, inspect the lift for binding of ropes or mooring systems. Resolve any issues.
Please review the Operation Manual for a full list of features and troubling shooting procedures
Содержание 18000 Long
Страница 1: ...1 Rev 07142020...
Страница 48: ...48 Rev 07142020 Appendix...
Страница 51: ...51 Rev 07142020...
