IMPORTANT SAFETY WARNINGS: SAVE THESE INSTRUCTIONS 5
Do not spray high pressure water on to the machine.
8. Disconnect power supply before making any repairs or adjustments.
9. Unit must be grounded. A grounding lug is provided on the machine
.
FIRE PRECAUTIONS:
1. Propane bottle equipped units must have the bottle removed from the
unit and placed 10 feet away before start-up.
2. NEVER operate this equipment in the presence of flammable vapors,
dust, gases, or other potentially combustible materials.
3. AVOID contact with the exterior of the coil/heat exchanger assembly and
exhaust stack to prevent burns.
4. DO NOT store fuel or other flammable materials near the burner or any
other open flame.
5. To avoid burns NEVER stand over burner exhaust outlet . Burner may
start at any time once power is turned on.
6. Do not touch burner exhaust port, mufflers, or wands/hoses as
contact may cause burns. Use designated gripping areas.
7. Burner on/off switch must be placed in the OFF position when
the pressure washer is not being used.
VENTILATION PRECAUTIONS:
1. DO NOT run burner in an enclosed area. Exhaust gases contain carbon
monoxide, an odorless deadly poison.
2.
Observe all State, Local, and National codes providing for indoor
use or installation of this unit.
3. If natural gas or propane odor is present, and/or unit does not light,
turn of all controls, close gas cock and call your gas company for
service.
4. Know the detergents you are using. Read and follow the
directions on the detergent labels.
PERSONAL HAZARD:
1. DO NOT remove belt guards or electrical covers while motor is
operating or when the power is connected.
2. DO NOT move engine powered machinery while the engine is
operating.
2. DO NOT lock the trigger on the gun valve in the on position.
3. DO NOT exceed recommended operating pressure or temperature.
4. KEEP HANDS CLEAR OF BELTS AND MOVING PARTS.
5. Do not operate the product when fatigued or under the influence of
alcohol or drugs.
LIMITATION OF LIABILITY
Hydro Tek's responsibility with respect to claims is limited in making
the required repairs or replacements. Hydro Tek reserves the right to
change or improve the design of any of its products or illustrations
without assuming any obligation to modify any product previously
manufactured.
THERE IS NO OTHER EXPRESSED WARRANTY.
This supersedes any and all previous warranty statements for
products purchased after June 1, 2001. Hydro Tek is not liable for
indirect, incidental or consequential damages including but not limited
to: The cost of substitute equipment, loss of revenue, pecuniary expense
or loss, or any damages whatsoever arising out of the use or inability to
use a Hydro Tek product. Hydro Tek disclaims all implied warranties,
including those of merchantability and fitness for use or a particular
purpose. It is the buyer's responsibility to ensure installation and use
of Hydro Tek products conforms to local codes.
Proof of purchase date required to obtain warranty.
ELECTRICAL PRECAUTIONS:
1.
Observe all State, Local, and National codes for the installation
of your electrically powered washer.
2. For a grounded product rated 250 volts, single phase, or less: This
Product Is Provided With A Ground Fault Circuit Interrupter Built
Into The Power Cord Plug. If Replacement Of The Plug Or Cord Is
Needed, Use Only Identical Replacement Parts.
3. GROUNDING INSTRUCTIONS:
Cord Connected, Grounded Products:
This product must be grounded. If it should malfunction or breakdown,
grounding provides a path of least resistance for electric current to reduce
the risk of electric shock. This product is equipped with a cord having
an equipment-grounding conductor. The plug must be plugged into an
appropriate outlet that is properly installed and grounded in accordance
with all local codes and ordinances.
Danger - Improper connection of the equipment-grounding conduc-
tor can result in a risk of electrocution. Check with a qualified
electrician or service personnel if you are in doubt as to whether the
outlet is properly grounded. Do not modify the plug provided with
the product, do not cut off the ground pin - if it will not fit the outlet,
have a proper outlet installed by a qualified electrician. Do not use
any type of adaptor with this product.
4. To comply with the national electric code, this pressure washer
should only be connected to a receptacle that is protected by a ground
fault circuit interrupter (GFCI).
5. EXTENSION CORDS:
Use of extension cords is not recommended.
6. NEVER operate an electrically powered washer after it has
tripped
a breaker or a ground fault device without having the reason
for the trip determined by an authorized service engineer or
competent electrician.
7. Use only in a dry area. Do not handle electrical cords and plugs when
they are wet, when your hands are wet, or when standing in water.
