8.
OPERATING INSTRUCTIONS
This manual contains all the information needed for the proper operation of this Whirlpool Bath.
WARNING:
BEFORE OPERATING REFER TO THE INSTRUCTIONS
PERTAINING TO THE RISK OF FIRE ELECTRICAL SHOCK OR INJURY TO
PERSONS ON THE LAST PAGE OF THIS MANUAL.
CAUTION
DO NOT OPERATE THIS UNIT WITHOUT THE GUARD COVER OVER
THE SUCTION FITTING.
TO OPERATE
1. Filling and Draining — Close the drain, fill tub with water at the desired temperature. The
maximum recommended bathing temperature is 104F (40C). The water must be at least
3" above the highest jet before activating the pump. Fill the tub to use h and drain it when
finished. Each bather should start their bath with fresh water.
NEVER ATTEMPT TO RUN THE PUMP MOTOR WITHOUT ENOUGH WATER TO
COVER ALL THE JETS.
2. On/ Off Button — Your tub is equipped with a pneumatic On/off Button.
To start a tub with a pneumatic ON/OFF Button, simply depress the ON/OFF button and
the pump will turn on. The button is an on/off switch. Depress the Button to turn on the
pump, depress it again to turn off the pump.
3. WHIRLPOOL JETS — The direction of the jets is adjustable. Point the jets down before
turning on the system. Some models have flow adjustable jets.
4. SUCTION — Never operate the whirlpool system with the guard cover over the suction
fitting. Keep hair, towels, and clothing away from the suction fitting whenever the
Hydromassage pump is on. The suction guard cover is a safety device designed to
eliminate the potential of hair and body entrapment.
WARNING:
Prolonged immersion in hot water may induce extremely high
body temperature (hyperthermia). Hyperthermia occurs when the internal
temperature of the body readies a level several degrees above the normal body
temperature of 98.6 F. The symptoms of hyperthermia include an increase in the
internal temperature of the body, dizziness, lethargy, drowsiness and Fainting.
