HydraMaster TITAN 425, Руководство пользователя и график технического обслуживания

Страница: 23 / 55

21 - TITAN 425 Owner’s Guide
SHUT-DOWN PROCEDURE
1. Flush clean water through the chemical system for 10 seconds. Turn the “CHEMICAL
SYSTEM” valve to “OFF”.
2. Cool the truckmount down by turning the “PUMP CLUTCH” switch to “PUMP ON-
NO HEAT”. Spray the cleaning wand into the vacuum hose for 3-5 minutes. The
chemical should now be flushed from the truckmount, hoses and cleaning tool.
3. Remove the vacuum hose.
4. Lubricate the blower to prevent it from rusting internally.
a. Allow the unit to run for a few minutes with the vacuum hose disconnected in
order to remove moisture from the blower.
b. Cap off the inlet(s) to the recovery tank.
c. Spray a Hydramaster-recommended spray lubricant into the “BLOWER LUBE
PORT” for about 5 to 10 seconds while the unit is running (see Figure 3).
d. Allow machine to run additional 2 to 5 minutes under load to flush off lubricant.
e. Uncap the inlet(s) and run the unit for another minute to allow the blower to cool
down.
5. If freeze guarding is necessary, perform the procedure at this time. See the Freeze
Guarding section of the Owner’s Manual.
6. Push the “THROTTLE” cable to the “IDLE ” position.
7. Turn the ignition switch to “OFF.
8. Drain the water box using the water box drain valve (see Figure 3) .
9. Drain the recovery tank in an appropriate location.
In accordance with EPA, state and local laws, do not dispose of water into gutters,
storm drains, streams or reservoirs.
10. Perform daily maintenance as specified in the Owner’s Manual.