HYDAC International MRF 2 NU, Инструкция по эксплуатации и техническому обслуживанию

Страница: 16 / 20

MRF 2 NU MultiRheo Filter
6.2 Installing a New Filter Element
6
1
1
2
7
IN
OUT
4
8
To install a new filter element, proceed as follows:
1. Moisten the sealing surfaces on the filter housing and the cover plate, including the O-
ring (8), if necessary, with clean operating fluid.
2. When installing a new filter element, check to see whether the designation on the new
element corresponds to the designation on the old one.
3. Wet the O-ring of the new element with hydraulic fluid.
4. Carefully place the filter element onto the element location spigot in the housing (note the
position of the handle on the element).
5. Place the housing cover on the flange of the tank. Apply the quick-action fastener (6),
align it and close it (tightening torque of screw = 27 Nm).
6. Screw in the safety screw (1) (with chain).
7. Close the "dirt side" drain plug (2).
8. Fill the filter side until oil exits at the air-bleed valve (4).
9. Close the air-bleed valve (4) in that line.
10. Check the filter for leaking.
Filter elements which cannot be cleaned are to be disposed of in an
environmentally safe and sound manner.
HYDAC Filtertechnik GmbH
en
Page 16
BeWa MRF2NU 3341025 en.doc 2007-09-24