Hyd-Mech P 225, Руководство по эксплуатации и обслуживанию

Страница: 13 / 41

P 225 9
CHAPTER 3
-- Installing the machine
3.1 -- Unpacking the machine
Hyd--Mech uses packaging that is appropriate for protecting the
machine from damage during transport right up until the time it is
delivered to the customer.
The type of packaging used for the machine depends on the
dimensions, weight and destination, so the customer will receive
the machine in one of the two following ways:
-- package including pallet, straps and cardboard box with
lid.
-- package with pallet, cardboard boxes (for more than one
machine) and wooden crate.
In either case, lift the machine using a fork lift truck, inserting the
forks at the points marked by the arrows and following the
instructions given on the box.
WARNING! Do not handle the
packaged machine by harnes-
sing with a sling.
Before installing the machine, remove the packaging, taking care
not to cut electric cables or hydraulic hoses and using pliers, a
hammer and a cutter as required. To place the machine in its
working position, follow the instructions given in paragraph 3.4.
The working position must be chosen taking into consideration
the machine dimensions and the space required to allow the
operator to perform all necessary manoeuvres to ensure his
safety.
3.2 -- Check list
Before beginning to install the machine, check the standard and
optional accessories provided with the machine. The standard
version of the P 225 1 SPEED sawing machine is supplied com-
plete with:
` pedestal with tank for coolant;
` membrane pump for lubrication and cooling of blade;
` IP 55 head control lever;
` mobile guard to cover part of blade not engaged in cutting;
`
rotating head with screw locking facility to perform angled cuts;
`
possibility of performing cuts from 0
_
to 45
°
to the left;
` 1 speed single--phase electric motor;
` bag of accessories.
The bag of accessories is enclosed in the machine before
packaging and contains the following accessories:
` 4, 5, 6, 10 mm Allen keys;
` rod for measured cuts;
` this operation and maintenance manual;
OPTIONAL
ACCESSORIES AVAILABLE ON REQUEST:
`
HSS DMo5/M2 D.225x32x2 circular blade for cutting solid
bars and profiles;
` 5 l can of emulsible oil.
3.3 -- Minimum requirements
The following are the minimum environmental requirements
needed to ensure correct operation of the machine:
-- mains voltage / frequency: see values given on the data plate;
-- room temperature: from -- 10 to + 50
°
C;
-- relative humidity: no higher than 90%;
-- room lighting: no lower than 500 Lux.
WARNING !
Although the machine is protected against voltage
variations, good operation can only be ensured by stable
voltage, which should not vary by more than

10%.
NO