Hyd-Mech P 225, Руководство по эксплуатации и обслуживанию

Страница: 10 / 41

Safety
P 225 6
Before starting to cut, make sure that the material
is adequately supported on both sides of the
machine.
Work may be carried out on the hydraulic and
pneumatic systems only after the pressure inside
them has been released.
The operator must avoid operations that are un-
safe or not appropriate for the job being
performed (e.g. removing swarf from the
machine while cutting).
Clear the cutting area of tools, implements and all
other objects; keep the working area as clean as
possible.
Before starting the cutting operation, make sure
that the workpiece is held securely by the vice
and that the machine is correctly set up. The
following are examples of how different section
bars can be locked on our sawing machines.
Do not use the machine for cutting workpieces
that exceed the capacity stated on the technical
sheet.
Do not move the machine while it is cutting.
Do not use blades with different dimensions from
those declared in the machine specifications.
When cutting extremely short workpieces, make
sure that they are not dragged behind the rest
shoulder as this gives rise to a risk of the blade
seizing.
When operating the saw, wear gloves only for
handling material and for adjusting or changing
the blade. Carry out only one operation at a time
and do not fill your hands with more than one
object at the same time. Keep your hands as
clean as possible.
Warning: if the blade seizes while cutting, imme-
diately press the machine’s emergency stop
button. If the blade does not free, open the vice
slowly, remove the workpiece and check that the
blade and the teeth are not broken. If they are,
replace the blade.
Before carrying out any repair work on the
machine, contact the Technical service centre or
if necessary its representatives in the country in
which the machine is used.
2.4 -- Machine safety devices
This operation and maintenance manual is not intended to be
solely a guide to using the machine for the purposes of
production, but provides instructions to ensure that it is used
correctly with a view to the safety of workers. Below is a list of the
standards prescribed by the EEC council contained in directives
regarding the safety of machinery, safety at the workplace,
personal
protection and environment protection. These
standards have been applied to the P 225.
2.4.1 -- Reference standards
SAFETY OF MACHINERY
`
EEC directive no. 98/37/CE of 14.06.1989 known as the
”Machinery directive”.
` EEC directives nos. 91/368;93/44;93/68 amending EEC di-
rective no. 98/37/CE regarding the safety of machinery.
` EEC directive no. 73/23 known as the ”Low tension
directive”.
SAFETY AT THE WORKPLACE
`
EEC directives nos. 80/1107; 83/477; 86/188; 88/188; 88/642
relating to the safeguarding of workers against risks deriving
from exposure to chemical, physical and biological agents
during work.
` EEC directive no. 89/391 and Special EEC directives no.
89/654 and no. 89/655 relating to the improvement of health
and safety of workers at work.
` EEC directive no. 90/394 relating to the safeguarding of
workers against risks deriving from exposure to carcinogenic
agents during work.
` EEC directives no. 77/576 and no. 79/640 regarding safety
signs at the workplace.
INDIVIDUAL PROTECTION
` EEC directives no. 89/656 and no. 89/686 regarding the use
of individual protective devices.
ENVIRONMENT PROTECTION
`
EEC directive no. 75/442 regarding waste disposal.
` EEC directive no. 75/439 regarding the disposal of used oil.