Hyd-Mech H14A, Руководство пользователя

Страница: 22 / 116

2.6
2.7
SINGLE PART CYCLE OPERATION
In MAN mode, the PLC allows the operator to initiate a “Single Part Cycle “ to cut one piece at a desired length. To accom-
plish this, follow the procedure below.
1. A trim cut should be made before initiating the “Single Part Cycle” operation.
2. Make sure the front vise switch is in the closed position and set the head up limit switch. The AUTO/MAN indicator
light will flash alternately green and red.
3. Make sure the head is set so that the blade is above the material and the head selector switch is in the HOLD
position.
4. The cursor will be flashing at the LENGTH position. Key in the
desired value from 0” to 220” and press enter. If the value is incor-
rect, re-enter the value and press enter again.
5. If the blade is not running, you will be prompted by the word
“BLADE” flashing on the display window. Start the blade and adjust the
blade speed as required.
6. When the blade is started, the word “BLADE” will change to the word
“CYCLE” flashing on the display window. Press CYCLE START and the
cycle will begin.
7. When the cycle button is pressed, the shuttle vise will move forward to the home position before executing the
length movement. The head will descend and make the cut.
8. When the cut is completed, the head will rise to the head up limit switch, the blade will stop and the display win-
dow will reset for the next cut.
9. To cut another piece, repeat steps 2 through 6.
NOTES:
1. To “PAUSE” the “SINGLE CUT CYCLE”, press the “CYCLE START” button. The “CYCLE START” button will be-
gin to flash and the screen will indicate a paused condition. All movements will immediately cease. To continue the
cycle, press “CYCLE START” button again.
2. To cut multiple pieces, switch to AUTO MODE and follow the automatic procedures.
KERF CORRECTION
When making cuts, the part length must be set longer than the desired length by an amount called the “KERF CORREC-
TION” or the kerf value (.066” for the 1 1/4” blade) must be adjusted. This is due to the fact that the PLC will not account
for the kerf value. If the kerf value is to be adjusted it’s value can be accessed while in Auto Mode. Press and hold the key
below the word “KERF” on the display until the display appears as shown. Enter the desired kerf value and press enter
NOTE:
Whenever a new job or new material is being loaded for production, the head up limit switch should be properly set to
clear the material, positioned for a trim cut and the front vise closed (in “MANUAL MODE”).
Returns
to Auto
Mode.
Returns
to the
Queue.
BLADE SPEED
LENGTH
FLASHING