Hyd-Mech H-14P, Руководство пользователя

Страница: 19 / 90

2.3
CoolanT - This switch has three positions, ON, OFF, and AUTO. In the ON position, the
coolant system will operate when there is power to the machine, this allows
using the wash gun to clean the machine. In the OFF position, the coolant
system is inactive. In the AUTO position the coolant system will only run when
the head is descending. This minimizes coolant carry over on the stock.
blaDE sPEED - This dial will increase or decrease the speed at any time while the blade is
running.
blaDE sToP - Stops the blade. If the blade is stopped during a cycle, the cycle will continue
but will not let the head descend until the blade is started.
sToP - This mushroom button stops the blade and hydraulic motors. Both vises will
hold their position but, pressure will begin to fall off. Long pieces of work
should always be supported so they will not become loose over time and fall
while the machine is shut down.
CENTER ROW
HYDRaUlIC sTaRT - To start the hydraulic system, the switches for the head and both vises
must be in the “NEUTRAL” position. The “HYDRAULIC START” but-
ton must be depressed and held in momentarily until the PLC display
becomes active.
CYClE sTaRT / PaUsE - This button starts the cutting cycles and will stay illuminated white until
the cycles are completed. The PLC control system will prompt you
to start the blade if it is not running. The machine will then begin the
automatic cycle until completed when it will shut itself off. The current
cycle can be PAUSED by pressing this button at any time during a
cycle and restarted by pressing it again.
WoRK laMP - This switch has two positions, OFF and ON.
lasER GUIDE -
This option switch has two positions, OFF and ON.
boTToM RoW