Hyd-Mech H-14P, Руководство пользователя

Страница: 23 / 90

2.7
. To “PAUSE” the cut, press the “CYCLE START/PAUSE” button, press it again to “RESUME”.
2. The blade speed, feed force and feed rate can all be adjusted during a cut if necessary.
3. To reset the material height, change the PLC to “MAN” and back to “AUTO”.
CoolanT floW
The main coolant control is found on the control panel.
WASH: Coolant flows any time the machine is under power, permitting wash down with
spray nozzle without running machine.
OFF: No coolant flow.
ON: The coolant flows only when the blade is running or when the blade is running and the
head is descending. This is selectable via the PLC parameters.
The bandsaw is equipped with two independently controlled coolant spouts that are capable
of supplying a generous flow of coolant to the blade.
The left guide arm supplies a flow of coolant that should flood the blade as it moves through
the carbide pads into the material to be cut. The adjustable spout on the left guide arm
should be set with the blade speed to provide the flood of coolant necessary.
The right guide arm provides a coolant flow through the flexible hose that can be pointed
directly where necessary. This flexible hose should be used when cutting solid bars, bundles, or wide structurals. Set the
flow of coolant directly into the opening in the material where the blade is cutting.
NOTE:
When cutting materials that do not need constant coolant, such as Cast Iron, some coolant flow is required for blade lubri -
cation to prevent blade scoring by the carbide pads as the blade moves through them.