Hyd-Mech H-14P, Руководство пользователя

Страница: 22 / 90

2.6
ManUal MoDE oPERaTIon
In MAN mode, the PLC allows the operator to make a single cut. To accomplish this, take the following steps.
. Open the vise.
2. Raise the head to so that the blade is above the material to be cut.
3. Load the material and position it for a cut, close the vise.
4. Set the feed rate (displayed) and feed force (not displayed) as described in Section 2B.
5. Start the blade and set the desired speed (displayed).
6. Turn on and adjust the coolant as required.
7. Turn the head switch to DOWN and the cut will begin.
8. When the cut is completed, raise the head.
9. To cut another piece, repeat steps 2 through 8.
NOTES:
• To “PAUSE” the cut, turn the HEAD switch to “HOLD” or “UP”.
• The blade speed, feed force, feed rate and guide arm can all be adjusted during a cut if necessary.
aUToMaTIC oPERaTIon
NOTE: Before entering AUTO mode, the head should be “HOMED” as the operator will be prompted to do so when the
“AUTO MODE” is accessed. See function button description for
. Open the vise.
2. Raise the head so that the blade is well above the material to be cut. This should be done to minimize the possi-
bility of damage to the blade while loading material.
3. Load the material and position it for a cut , close the vise.
4. Set the feed rate (displayed) and feed force (not displayed) as described in Section 2B.
5. If the blade speed must be adjusted, start the blade and set the desired speed (displayed).
6. Press the key, the blade will stop if it is running, and the display will change to that shown below.
When the AUTO/MAN button is pressed, the red indicator light above it will come on, and the blade will stop if it
has been running and all manual functions will be disabled.
7. Press the “CYCLE START/PAUSE” button, the vise must be closed, and the display will change as shown below.
If the head has not been “HOMED”, you will be prompted to do so.
8. The HEAD switch is now enabled, move the head to a position just above the material to be cut. When the head
is in position, turn the switch to “HOLD”.
NOTE: If the switch is left in “DOWN” and the ENTER key is used while the head is moving, do not change the
PLC to “MAN” mode. The HEAD switch should ALWAYS be turned to “HOLD” as the head will begin to
MOVE IMMEDIATELY when the key is pressed to switch to “MAN” mode.
9. Press the ENTER key and the cut will begin. If the blade is not running, the head will not move, the display will
prompt you to start the blade.
0. When the cut is complete, the head will rise to the set material height and the blade will stop.
. To cut another piece, repeat steps 3 through 9.
NOTES:
HOME
AUTO
MAN
AUTO
MAN